https://www.ninja250.info/index.php?action=history&feed=atom&title=Corbin_seat_fitting 2026-10-23T05:53:26Z Revision history for this page on the wiki MediaWiki 1.43.11 https://www.ninja250.info/index.php?title=Corbin_seat_fitting&diff=8213&oldid=prev 2009-07-17T01:50:37Z

<p></p> <p><b>New page</b></p><div>[[Category: Luggage &amp; Touring]]<br /> As is typical with Corbin products, the quality on the Corbin Gunfighter &amp; Lady seat is first-rate. However, when you pull off your OEM seat, you may have trouble getting the Corbin to latch in its place. This should not be a big surprise, as their tolerances are &#039;&#039;very, very tight&#039;&#039;. Some people might be tempted to grab a knife and whittle down the rubber stops. &#039;&#039;&#039;Do not ever do this to your Corbin seat&#039;&#039;&#039;. The rubber stops will mold to your frame over time, and it is important you don&#039;t chop them up. If you have this problem, buy some 1/4 inch washers with a height of approximately .75 mm to place under the latches to lessen the tolerance. One washer on the driver&#039;s side and two on the passenger side worked here. <br /> <br /> [[image:corbinmod4.jpg|150px]]<br /> [[image:corbinmod3.jpg|150px]]<br /> <br /> [[image:corbinmod5.jpg|150px]]<br /> [[image:corbinmod6.jpg|150px]]</div>

Bokonon