Ninja 250 Carburetor Needle Information: Difference between revisions
No edit summary |
|||
| Line 160: | Line 160: | ||
mm thick, so that the needle can be adjusted in about half-millimeter | mm thick, so that the needle can be adjusted in about half-millimeter | ||
increments. | increments. | ||
==DynoJet== | |||
[[File:jetneedle.jpg]] | |||
<table border=0> | |||
<tr> | |||
<th> Diameter/Taper </th> | |||
<th> Length </th> | |||
<th> Colored line </th> | |||
</tr> | |||
<tr> | |||
<td> 2.44mm diameter </td> | |||
<td> Unknown </td> | |||
<td> To black line </td> | |||
</tr> | |||
<tr> | |||
<td> 2.44 - 1.92 mm taper </td> | |||
<td> 15.47 mm </td> | |||
<td> Black to blue line </td> | |||
</tr> | |||
<tr> | |||
<td> 1.92 - 1.11 mm taper </td> | |||
<td> 2.5 mm </td> | |||
<td> Blue to yellow line </td> | |||
</tr> | |||
<tr> | |||
<td> 1.11 mm diameter </td> | |||
<td> 13.18 mm </td> | |||
<td> Yellow to red line </td> | |||
</tr> | |||
</table> | |||