Installing Blazer Flushmounts: Difference between revisions

Line 14:

* Six bolts with nuts and washers (three per light base). Chances are that you have them already laying around your garage.

* Two nuts for the lens attachment (size unknown)

* ~~Hacksaw and scissors~~

* Sabre saw or manual reciprocal saw

* Pliers ~~and screwdrivers~~

* Scissors

* Pliers

* Screwdrivers

* Super glue

Line 25:

Line 27:

* Cut the base so the bulb itself can slide through.

To cut the base, ~~use~~ a ~~hacksaw and pliers~~. You should get something like this:

To cut the base use a sabre saw, a , or something similar. You should get something like this:

[[image:bl-05.jpg|150px]]

Line 62:

Line 64:

[[image:bl-15.jpg|150px]]

The only thing is left to do is attach the lens. You need to find a nut that will fit under the housing and superglue it so it will stay in place. Remove the bulb, put a drop of ~~superglue~~ on the nut, and place it as shown in the picture below. Be careful with the ~~superglue~~; don't get it on the lens.

The only thing is left to do is attach the lens. You need to find a nut that will fit under the housing and superglue it so it will stay in place. Remove the bulb, put a drop of super glue on the nut, and place it as shown in the picture below. Be careful with the glue; don't get it on the lens.

[[image:bl-08.jpg|150px]]

@@ Line 14: / Line 14: @@
 * Six bolts with nuts and washers (three per light base). Chances are that you have them already laying around your garage.
 * Two nuts for the lens attachment (size unknown)
-* Hacksaw and scissors
+* Sabre saw or manual reciprocal saw
-* Pliers and screwdrivers
+* Scissors
+* Pliers
+* Screwdrivers
 * Super glue
@@ Line 25: / Line 27: @@
 * Cut the base so the bulb itself can slide through.
-To cut the base, use a hacksaw and pliers. You should get something like this:
+To cut the base use a sabre saw, a , or something similar. You should get something like this:
 [[image:bl-05.jpg|150px]]
@@ Line 62: / Line 64: @@
 [[image:bl-15.jpg|150px]]
-The only thing is left to do is attach the lens. You need to find a nut that will fit under the housing and superglue it so it will stay in place. Remove the bulb, put a drop of superglue on the nut, and place it as shown in the picture below. Be careful with the superglue; don't get it on the lens.
+The only thing is left to do is attach the lens. You need to find a nut that will fit under the housing and superglue it so it will stay in place. Remove the bulb, put a drop of super glue on the nut, and place it as shown in the picture below. Be careful with the glue; don't get it on the lens.
 [[image:bl-08.jpg|150px]]