My LED turn signals don't work right: Difference between revisions
| Line 57: | Line 57: | ||
At the six-connection plug under the headlight, use a paper clip to remove the green and grey wires from the male side of the plug. In stock form, these wires bring power to the "your signals are on" dash light. You are going to splice into these wires. When you do, leave enough wire on both ends to make the splice, ie... make your cut several inches back from the connector. | At the six-connection plug under the headlight, use a paper clip to remove the green and grey wires from the male side of the plug. In stock form, these wires bring power to the "your signals are on" dash light. You are going to splice into these wires. When you do, leave enough wire on both ends to make the splice, ie... make your cut several inches back from the connector. | ||
[[Soldering 101|Solder]] the anode (+) end of the diodes | Set aside the connector end of the wires that you cut off for now. Take the green and grey wires coming from the harness and [[Soldering 101|Solder]] the anode (+) end of one of the diodes to green one. Solder the anode of the other diode to the grey wire. Then you need to solder the cathode (-) end of both diodes together to the end of the green wire (with connector attached) that you cut off. What this does is make one hot wire out of two. | ||
[[image:1SixPlugConn-REV1.jpg|150px]] | [[image:1SixPlugConn-REV1.jpg|150px]] | ||