Oil Change Procedure: Difference between revisions
| Line 26: | Line 26: | ||
[[Image:3Winterize.jpg|180px]] | [[Image:3Winterize.jpg|180px]] | ||
Before replacing the filter, install new o-rings on the filter bolt and plate. Note that many riders do not replace the small o-ring at every oil change; if you don't separate the bolt from the plate, you should maintain a good seal. | Before replacing the filter, install new o-rings on the filter bolt and plate. Coat the O-rings with oil before installation. Not doing so could cause a tear when you put everything back on. | ||
[[image:600.jpg|150px]] | |||
Note that many riders do not replace the small o-ring at every oil change; if you don't separate the bolt from the plate, you should maintain a good seal. | |||
[[Image:4Winterize.jpg|200px]] [[Image:5Winterize.jpg|160px]] | [[Image:4Winterize.jpg|200px]] [[Image:5Winterize.jpg|160px]] | ||
| Line 38: | Line 42: | ||
[[Image:7Winterize.jpg|180px]] | [[Image:7Winterize.jpg|180px]] | ||
Then, place the filter element on the bolt | Then, place the filter element on the bolt. Dip your finger in your new oil and spread a bit around the two inner grommets on the filter, where it rides over the bolt. Then add the retainer as shown. | ||
[[Image:8Winterize.jpg|180px]] | [[Image:8Winterize.jpg|180px]] | ||