Washers for carb needles: Difference between revisions
From Ninja250Wiki
Jump to navigationJump to search
No edit summary |
No edit summary |
||
| Line 6: | Line 6: | ||
*thickness = 0.0400" , 1.016mm | *thickness = 0.0400" , 1.016mm | ||
If you can't find #4 washers, try to get an assortment that is close in dimension. Those with 2.5 - 3mm inside diameter, and not being too much larger than 3/8"/9.5mm should be fine. As always, it's better to get a few more than you need, rather than having to keep going back to the store. | If you can't find #4 washers, try to get an assortment that is close in dimension. Those with 2.5 - 3mm inside diameter, and not being too much larger than 3/8"/9.5mm outside should be fine. As always, it's better to get a few more than you need, rather than having to keep going back to the store. | ||
Revision as of 10:30, 13 December 2008
For shimming your carb needles you need to look for #4 washers. These have the following dimensions, listed in decimal, fractional, and metric sizes:
- ID = 0.1250" , 1/8" , 3.175mm
- OD = 0.3750" , 3/8" , 9.525mm
- thickness = 0.0400" , 1.016mm
If you can't find #4 washers, try to get an assortment that is close in dimension. Those with 2.5 - 3mm inside diameter, and not being too much larger than 3/8"/9.5mm outside should be fine. As always, it's better to get a few more than you need, rather than having to keep going back to the store.
