Oil Change Procedure: Difference between revisions

Line 16:

Wipe a small amount of new oil onto the gaskets on the inside of the filter which contact the bolt and onto the big o-ring, and then place the new filter (see [[Oil Filters|oil filter page]] for options) on the retainer and replace the assembly, again torquing the bolt to 14.5 ft/lbs. Open the filler cap on the right side of engine if you haven't already. Fill w/ 1.5 qts of your favorite oil. Wait a minute, then add a very small amount of oil at a time until oil is halfway up the level-check window (aka "sight glass"). Replace the filler cap. Start up the bike and let it run for a minute, then shut off the engine and wait a few minutes before checking the window again. Put another few ounces of oil in. Repeat until oil level is consistently in the center of the view window.

When the bike is on its centerstand the level in the sight glass will be lower. When both wheels are on the ground the level will show a more full reading. (The bike is tilted forward and isn't level when on the centerstand, so the level appears a little lower.) The recommended [How do I check my oil?|check method] is with both wheels on the ground, but there's only a small variation between on and off the centerstand; as long as you're in the middle of the sight glass or above with either method you're fine. Be happy and go ride. It doesn't have to be exact.

'''Note''': When the bike is on its centerstand the level in the sight glass will be lower. When both wheels are on the ground the level will show a more full reading. (The bike is tilted forward and isn't level when on the centerstand, so the level appears a little lower.) The recommended [[How do I check my oil?|check method]] is with both wheels on the ground, but there's only a small variation between on and off the centerstand; as long as you're in the middle of the sight glass or above with either method you're fine. Be happy and go ride. It doesn't have to be exact.

Do not overfill (you could blow a gasket).

@@ Line 16: / Line 16: @@
 Wipe a small amount of new oil onto the gaskets on the inside of the filter which contact the bolt and onto the big o-ring, and then place the new filter (see [[Oil Filters|oil filter page]] for options) on the retainer and replace the assembly, again torquing the bolt to 14.5 ft/lbs. Open the filler cap on the right side of engine if you haven't already. Fill w/ 1.5 qts of your favorite oil. Wait a minute, then add a very small amount of oil at a time until oil is halfway up the level-check window (aka "sight glass"). Replace the filler cap. Start up the bike and let it run for a minute, then shut off the engine and wait a few minutes before checking the window again. Put another few ounces of oil in. Repeat until oil level is consistently in the center of the view window.
-When the bike is on its centerstand the level in the sight glass will be lower. When both wheels are on the ground the level will show a more full reading. (The bike is tilted forward and isn't level when on the centerstand, so the level appears a little lower.) The recommended [How do I check my oil?|check method] is with both wheels on the ground, but there's only a small variation between on and off the centerstand; as long as you're in the middle of the sight glass or above with either method you're fine. Be happy and go ride. It doesn't have to be exact.
+'''Note''': When the bike is on its centerstand the level in the sight glass will be lower. When both wheels are on the ground the level will show a more full reading. (The bike is tilted forward and isn't level when on the centerstand, so the level appears a little lower.) The recommended [[How do I check my oil?|check method]] is with both wheels on the ground, but there's only a small variation between on and off the centerstand; as long as you're in the middle of the sight glass or above with either method you're fine. Be happy and go ride. It doesn't have to be exact.
 Do not overfill (you could blow a gasket).